Wind Turbine Kits, 500W Micro Hydraulic Turbine Generator Water Electromagnet Full Copper Core High Performance Household
★The cast aluminium alloy shell, corrosion protection, acid and alkali resistance, salt corrosion resistance
★The generator uses the best Ndfeb permanent magnets and a high-quality pure copper
-
Detail
Installation steps:
After establishing the unit, the cast concrete is solidified, the device is installed and then watered one by one. The water level must be measured with a water level meter to ensure that the device is held in a horizontal position. The gap between the equipment and the floor should be sealed. With cement and no ingress of water. After installing the equipment, check and turn the turbine shaft of the turbine by hand. If the machine is flexible, the installation is complete.
Installation requirements: the bottom of the turbine is in close contact with the base level.
Note:
The 500W hydropower generator can only be used under the following two conditions:
1) The vertical water level difference between the device base and the hydrogenerator must be within the following range:5-15m
2) The water flow must always be filled with water pipes with a diameter of more than 7.5 cm.
Specifications:
Output voltage: 220V AC
Power: 500 W
Nozzle diameter: 1.8 cm
Water level difference: 7-15 m
Flow rate: 0.008-0.011 m3/S
Pressure tube diameter: 8 cm (3 inches).
Material: copper and metal.
Weight: 20 kg.
Box contents:
1 x micro hydro generator -
Customer ReviewsNo comments