Wind Turbine Generator Kit 600W 12V w/8 Blade, Wind Generator Kit w/Charge Controller, Wind Power Generator for Marine, Home, Windmill Generator Suit for Hybrid Solar Wind System

This 600W wind turbine generator kit includes a wind turbine, anemometer, controller, 8 blades, and other accessories, providing you with a powerful tool to help generate electricity through wind.

It features high efficiency, and strong performance that contributes to the annual power generation.It's worth trying!

Package Included: 1* Wind Turbine; 8* Blades; 1* Wind Wheel; 1* Controller; 1* Anemometer; 1* Flange Plate; 1* English Manual; Other Accessories for Assembly.

Notes

1. This package does not include a tower tube, and we recommend using a steel pipe or iron pipe of 1.65-1.77" in diameter.

2. The wind turbine should be installed where there is strong wind or without tall buildings and obstacles.If installing it near the obstacles, the position is better as far as possible from obstructions, or the installation height should be 20ft higher than the top of obstructions, which can make full use of the wind power.It should avoid the cliff and the turbulent region.

3. The power of the wind turbine will increase with the wind speed.When the wind speed is very low, the wind wheel of the wind turbine will remain stationary.When the cut-in wind speed is reached (usually 3m/s), the wind wheel starts to rotate and the generator starts to generate electricity.As the wind becomes stronger, the output power will increase.When the wind speed reaches the rated wind speed, the wind turbine will output its rated power.After that, the output power will remain roughly unchanged.When the wind speed increases further and reaches the cut-out wind speed, the wind turbine will brake without power output to avoid damage.

4. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before you order.

MaterialNylon F-i-b-e-r, Die-casting Aluminum Alloy, Neodymium Iron BoronInstallation MethodVertical TypeWind Direction AdjustmentAutomatically Adjust the Windward AngleGenerator Type3-Phase AC Permanent Magnet GeneratorBraking MethodElectromagneticNumber of Blades8Rated Power600WMax.Power650WStart-up Wind Speed3m/sRated Wind Speed13m/sSafe Wind Speed50m/sMax.Wind Speed60m/sWorking Temperature-40 ~ 80 ℃/-40-176℉ Blade Length(Each)40cm/15.7inchTower Tube Diameter42-45mm/1.65-1.77inch(Not Included)

How to Install?

1. Take out the wind turbine, put it on the tower, and align it with the flange holes. Install four flat washers on the four bolts, and then insert the bolts into the corresponding holes of the flange. Tighten the screws with an Allen key.

2. The three wires of the wind turbine are connected with the transmission cable, each pair of wires is not less than 30mm, and the adhesive tape at the connection end is 100mm.

3. Connect the wind turbine cable to the controller. The battery must be connected to the controller before wiring.

WATEBATH Wind Turbine Generator Kit

Anemometer

Specifications