Wind Turbine Generator 400W 24V 6-Blade Wind Power Generator with Mppt Charge Controller,RV Wind Power Generator, Off Grid Windmill Generator Suit for Hybrid Solar Wind System

Wind wheel diameter

1.Three-phase permanent magnet synchronous motor. High efficiency compact alternator with high performance NdFeB permanent magnets.

2. The patented alternator is equipped with a special stator, which effectively reduces the torque and is perfectly adapted to the wind turbine, improving the efficiency of the whole system.

3. The wind turbine is controlled by MPPT intelligent microprocessor, which can effectively regulate current and voltage. Fully-integrated voltage regulator can be automatically switched off when the battery is fully charged.

4. Thanks to the double-bearing design, the fan movement is particularly stable and has low vibration, thus reducing noise. The compact structural design allows for low start-up speeds and a large windward area, so power can be generated even at low wind speeds.

Connect the red cable on the controller to the positive terminal of the battery. Connect the black cable to the negative terminal of the battery. The three green cables on the controller need to be connected to the three cables of the wind turbine (these three cables can be connected arbitrarily). See schematic diagram.

NOTE: Do not reverse the positive and negative terminals as this may damage the controller.

1. The wind turbine should be installed where there is strong wind and no tall buildings or obstacles. If the wind turbines are installed near obstacles, the position should be as far away from obstacles as possible, or the installation height should be 20 feet higher than the top of the obstacles (as shown), so that full use can be made of the wind power.

2. We can take advantage of the growth effect on hills (as shown). It is a good place to set up.

3. It should avoid cliffs and turbulent regions.

High efficiency

Connection Instructions: